12V 3-Wire Exhaust 10871 Replace 270-10871 Stop Solenoid for Corsa Marine Captain

12V 3-Wire Exhaust 10871 Replace 270-10871 Stop Solenoid for Corsa Marine Captain

Note:If you have a 4-Wire solenoid, you must buy this one and re-wire with a new 3 wire plug. The older model 270-10871 solenoid has also been superseded to this model.

Replace Part Number:
10871,270-10871,27010871

Specification:
Three-Wire Solenoid Testing Procedure (Black Connector)
1. Disconnect solenoid from harness at quick disconnect and check terminals for corrosion. Terminal plugs should be locked in place to the connector and should not come out. If terminals come out to the connector easily, it may not be making good contact with the mating terminal.
2. If terminals are free of corrosion and are firmly held in place in connector, jumper wires directly to the battery, as indicated in the diagram and following test procedure, to determine if the solenoid is functioning properly.
(see the last photo)
Connect the black wire first, followed by the white wire. When the red wire is connected the
solenoid, plunger should pull in and stay in until either the red or black wire is disconnected. The white and black wires should stay cool even after a few seconds have passed. When disconnected the solenoid should return to its previous position.
3. If the solenoid fails the above procedure, the white or black wires get hot, or the contacts are highly corroded.

Application:
Fit For Corsa Electric Captain's Call Systems